Location        Home        Products        Waterborne Epoxy Floor Intermediate Coat

Waterborne Epoxy Floor Intermediate Coat

Name: Kingcoat FIC-1800WB
Introduction:

     A two-component, ambient temperature cure, waterborne epoxy intermediate coat which is based on the primer resin (Kingcoat FP-400WB) or the top coat (Kingcoat FT-600WB), and made by adding an appropriate amount of pigments and fillers. This system is applied for coating on cementitious substrates. When it cures, it forms a tough and hard finish with good adhesion between both primer and topcoat, and enhances overall properties of the concrete floor, including abrasion, compression and impact resistances. The coat formed is resistant to many chemicals, oil and water. It allows the floor concrete to “breathe” and is a high build, eco-friendly epoxy flooring.

Mixing Ratio: A-component/B-component=9/1(weight)
Package: A-component=18kg, B-component=2kg
       Information

Application Advantages
? Eco-friendly, being water based composition
? High filler content, cost-effectiveness
? Can be used for self-leveling
? Breathable
? Can be applied on flesh as well as old concrete
? Excellent abrasion and scratch resistances
? Resistance to chemicals, oil and water
? Provides good adhesion between both primer and topcoat
? enhances overall properties of the concrete floor, including abrasion, compression and impact resistances
Application Procedure
   While applying Kingcoat FIC-1800WB coat, surface preparation is the most important part. Remove all the loose materials to expose the base surface. Wash the surface with plenty of water. A 10% muriatic acid solution wash should follow. Again wash the surface with plenty of water. Let the surface dry to saturated surface dry (SSD) condition. Fill all the cracks, honey-combs, voids etc, using cement mortar or our Kingbond repair compound. Let the surface dry completely and polish it withgrinding leveling. Apply a coat of Kingcoat FP-400WB liberally by brush or roller over the surface. Allow the surface to be touch-dry. Mix the A and B parts of Kingcoat FIC-1800WB thoroughly, to get a uniform consistency. Trowel the first coat over this primer coat. Allow the coat to cure for 12 hours. Again trowel the second coat over the first coat, preferably in a perpendicular direction to the first coat, and so on until the coating thickness. Let the system cure for 24 hours. Protect the treatment during the curing period from mechanical disturbances, water splashes, direct sunlight & heat.
Application Areas
? Industrial manufacturing facilities, warehouses, airports
? Chemical and pharmaceutical industries
? Food processing and dairy plant flooring
? Car park, basement, non-skid floors
? Institutional facilities, schools, residences, hospitals
? Commercial traffic floors